Good tools for an easy life.

Common sense about angle grinders of power tool companies

by:WORKSITE     2021-01-08
In the process of receiving customers from the sales staff of the power tool company, it was found that the dealer was still not clear about the replacement and disassembly methods of angle grinders. Next, I will tell you the specific method:

(1) The first is the installation of the wheel cover:

Install the protective cover into the front cover and tighten the fastening screws. The protective cover is installed. The protective cover can be adjusted to any position according to the operation needs: loosen the fastening screw, rotate the protective cover to the desired position, and then tighten the fastening screw.

(2) Install and remove the grinding wheel

Remember: Before installing or removing the grinding wheel, be sure to unplug the plug from the power supply. The safety line speed of the grinding wheel is not less than 80m/s.

Install the grinding wheel: Install the lower pressing plate, grinding wheel and upper pressing plate on the output shaft in turn, press the self-locking button, and tighten the upper pressing plate with a wrench.

Note: When installing the grinding wheel, the groove of the lower platen must be aligned with the flat square of the output shaft and the grinding wheel must be clamped.

Dismantling the grinding wheel: Press the self-locking button and loosen the upper pressure plate with a wrench to remove the grinding wheel.

(3) Switch on and off

Note: Before inserting the plug into the power supply, check that the self-locking button is in the pop-up state, and the switch lever is flexible and in the '0' position. Move the switch lever to 'I' to start the tool and run continuously. Turn the switch lever to '0' and the tool is turned off and gradually stops running.

(4) Replace carbon brush

The carbon brush should be replaced when the tool has large sparks or stops running during operation. Use a screwdriver to unscrew the carbon brush cover, take out the worn carbon brush and install a new carbon brush, and confirm that the carbon brush slides freely in the hole, and then tighten the carbon brush cover. Be sure to replace both carbon brushes at the same time, and use the original carbon brushes.
Custom message
Chat Online
Chat Online
Chat Online inputting...