Safety operation rules and precautions of electric hammer
1. Personal protection when using electric hammer 1. The operator should wear protective glasses to protect his eyes, and wear a protective mask when working with the face up. 2. Keep earplugs in place for long-term operations to mitigate the effects of noise. 3. The drill bit is in a hot state after long-term operation, and you should pay attention to burn your skin when replacing it. 4. The side handle should be used during operation, and it should be operated with both hands, so that the arm will be sprained by the reaction force when the rotation is blocked. 5. When working on a ladder or working at a high place, measures for falling from a high place should be taken, and the ladder should be supported by ground personnel. 2. Matters needing attention before operation 1. Confirm whether the power supply connected to the site matches the nameplate of the electric hammer. Whether there is a leakage protector. 2. The drill bit and the gripper should be adapted and properly installed. 3. When drilling walls, ceilings, and floors, you should first confirm whether there are buried cables or pipes. 4. When working in high places, pay full attention to the safety of the objects and pedestrians below, and set warning signs if necessary. 5. Confirm whether the switch on the hammer is cut off. If the power switch is turned on, the power tool will turn unexpectedly immediately when the plug is inserted into the power socket, which may cause personal injury. 6. If the working place is far away from the power source, when the cable needs to be extended, sufficient capacity should be used to install a qualified extension cable. The extension cable should be elevated or pass through measures to prevent the cable from being damaged by rolling.