Good tools for an easy life.

The power tool company tells you the common sense

by:WORKSITE     2021-01-10
In the process of entertaining customers by the sales staff of the electric stuff company, it was discovered that the dealer still didn't quite understand how to replace and disassemble the angle grinder. Next, I will tell you the specific method:

(1) The first is the equipment of the wheel cover:

Put the protective cover into the front cover and tighten the fastening screws. The protective cover is complete. According to the operation requirements, the protective cover can be adjusted to any position: loosen the fastening screw, rotate the protective cover to the required position, and then tighten the fastening screw.

(2) Equipment, disassemble the grinding wheel

Remember: Before disassembling the grinding wheel, you must unplug the plug from the power supply. The safety line speed of the grinding wheel is not less than 80m/s.

Equipment grinding wheel: Place the lower pressing plate, grinding wheel and upper pressing plate on the output shaft in turn, press the self-locking button, and tighten the upper pressing plate with a wrench.

Pay attention: When the equipment is grinding wheel, the groove of the lower plate should be aligned with the flat square of the output shaft and the grinding wheel must be clamped.

Disassemble the grinding wheel: Press the self-locking button and loosen the upper plate with a wrench to remove the grinding wheel.

(3) Opening and closing of the switch

Note: Before the plug is inserted into the power supply, check that the self-locking button is in the pop-up condition, and the switch lever is active and in the '0' position. Move the switch lever to 'I' and start working continuously. Turn the switch lever to '0' to close things and gradually interrupt the operation.

(4) Replace carbon brush

The carbon brush should be replaced when the object has large sparks or intermittent operation during operation. Unscrew the carbon brush cover with a screwdriver, take out the worn carbon brush and install a new carbon brush, and admit that the carbon brush slides freely in the hole, then tighten the carbon brush cover. It is necessary to replace the two carbon brushes together and use the original carbon brushes.
Custom message
Chat Online
Chat Online
Chat Online inputting...